C 300 (204.054) V6-3.0L (272.947) (2008)
Component Identification
3
Press-out bearing (1).
4
Check inside of torque strut (2).
If there are score marks on the inside of the torque strut (2), this should be replaced.
Component Identification
5
Align bearing (1) with the side of the chamfer as per the marking (see figure).
The recess clearance (3) must point centrally towards the ball head (4), the rubber lug (5) must be in the same direction as the ball head (4) (see
picture).
Component Identification
6
Press in bearing (1) as far as the stop.