C 320 Wagon (203.264) V6-3.2L (112.946) (2004)
Sunroof / Moonroof Panel: Adjustments
AR77.20-P-1100P Adjust Tilting/Sliding Roof Cover
- with CODE (414a) Glass electric tilting/sliding roof
Shown On Model 203.0
1
Slide cover (2) to rear
2
Move sliding/tilting roof about 20 cm to the rear
3
Remove cover (1)
NOTE:
For Model 203.0: Push panel (2) away with plastic wedge in the middle before pulling of)
For Model 203.2: Push panel (2) away with plastic wedge in the middle and on the side before pulling off
See "Special Tools - Assembly Wedge" given below.
4
Move sliding/tilting roof into tilt position
5
Pull off rubber bellows (4)
CAUTION: Do not damage rubber bellows (4)
6
Close sliding/pop-up roof
Adjusting
7
Loosen Torx screws (5)
See "Special Tools - Torx Bit Set" given below.
8
Insert cardboard strips (6) into sealing joint at the rear
NOTE: Cardboard strips (6) 500 mm long and about 2 mm thick
9
Adjust pop-up/sliding roof panel (3) in relation to exterior roof surface
Gap Dimensions
Sliding/pop-up Roof Cover, Front - 0.15 m.m
Sliding/pop-up Roof Cover, On Side And Rear - 0.30 m.m
Height