C 320 Wagon (203.264) V6-3.2L (112.946) (2004)
Radiator: Procedures
Removing and Installing Radiator
1
Remove electric fan
DANGER:
-
Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant.
-
Do not open cooling system unless coolant temperature is below 90 degrees C. Open cap slowly and release the pressure. Do not pour
coolant into beverage bottles.
-
Wear protective gloves, protective clothing and eye protection.
2
Drain coolant
3
Take off coolant line radiator -> Coolant pump (1) at radiator (2)
-
Use a screwdriver to push back clamp (3) until it locks in place.
NOTE: Installation: Replace O-ring (4) of coolant line radiator-> Coolant pump (1).
4
Take off coolant line radiator -> thermostat housing (5) at radiator (2)
-
Use a screwdriver to push back clamp (6) until it locks in place.
NOTE: Installation: Replace O-ring (7) of coolant line radiator -> thermostat housing (5)
5
Detach bracket (8) of ATF lines (9, 10)\
-
Only on models fitted with transmission 722.6.
6
Detach ATF lines (9, 10) at radiator (2)
-
Only on models fitted with transmission 722.6.
NOTE: Installation: Check clamps (11), replace if necessary. Replace O-rings of ATF lines (9, 10).
7
Press ATF line (10) out of bracket (12)
-
Only on models fitted with transmission 722.6.