C 320 Wagon (203.264) V6-3.2L (112.946) (2004)
/v6-3.2l_(112.946)/Page-3641005.png)
Caution!
Do not touch the glass portion of the burner with bare hands; otherwise the glass envelope will shatter when energized. Use a non-greasy, soft cloth.
7.14 Push the new ignition module (A002 546 13 41) onto the collar until it snaps in place (Figure 8).
Note:
Ensure the correct installation position (Figure 8, right headlamp A, left headlamp B). Install new housing cover at rear of headlamp.
7.15 Test operation of lamp unit
7.16 Install removed parts in reverse order.
8. For 203.7 & 209 models with this complaint and with headlamps manufactured on or before manufacture dates (Figure 1) in the above table, proceed
as follow to resolve.
8.1 Remove front wheel. Reference WIS document no.AP40.10-P-4050Z.
8.2 Remove front fender liner. Reference WIS document no. AR88.10-P-1300P.10-P-1300P.
8.3 Disconnect plug from headlamp.
8.4 Unlock and remove housing cover on rear of headlamp unit at the tab and scrap housing cover.
8.5 Twist plug on burner to the left and remove.
8.6 Cut off burner plug as close to the ignition module as possible (Figure 9) and scrap burner plug.
