mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

AP27.00-P-2702P Automatic Transmission - Oil and Filter Change|Page 2631 > < AP27.00-P-2702P Automatic Transmission - Oil and Filter Change|Page 2629
Page 2
background image

necessary. The correct oil level should be measured at a transmission oil temperature of 80 degree C.

NOTE:  At a transmission fluid temperature of 25 degree C, the fluid level must be within the range "A". At a transmission fluid temperature of 
80 degree C, the fluid level must be within the range "B".

12

Warm up transmission

NOTE:  Wait at least two minutes after reaching a transmission oil temperature of 80 degree C.

13

Move selector lever to position "R" or "D"

NOTE:  Apply service brake.

14

Check transmission oil level

NOTE:  Move selector lever to position "P".

15

Correct transmission oil level

NOTE:  If too much transmission oil is added, it is absolutely essential to drain off or extract the surplus.

16

Check transmission for leaks

CAUTION:  If loss of oil present, determine cause and rectify. An insufficient or excessive oil quantity causes malfunctions and
transmission damage.

Install

17

Fit cap (93) on oil filler tube

18

Press in new locking pin (93a)

NOTE:  The locking pin (93a) must lock in place.

AP27.00-P-2702P Automatic Transmission - Oil and Filter Change|Page 2631 > < AP27.00-P-2702P Automatic Transmission - Oil and Filter Change|Page 2629