C 320 Wagon (203.264) V6-3.2L (112.946) (2004)
Oil Level Sensor: Procedures
Remove/Install Oil Level Sensor
Shown On Engine 111
DANGER:
-
Risk of death, Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by
the vehicle manufacturer.
1
Remove engine compartment paneling
2
Drain and collect engine oil
CAUTION: Installation: Replace seal of oil drain plug, in order to avoid oil leakage.
3
Unplug connector (1)
4
Unscrew screw (2)
5
Remove oil sensor (oil level, temperature and quality) (B40)
CAUTION: Installation: Replace O-ring (3) from oil sensor (oil level, temperature and quality) (B40), in order to avoid oil leakage.
6
Install in the reverse order.