C 350 4MATIC (203.087) V6-3.5L (272.970) (2007)
Brake Pad: Service and Repair
AR42.10-P-1700P Remove/Check/Install Rear Axle Brake Pads
Remove/check/install Rear Axle Brake Pads
Shown On Model 203
DANGER:
-
Risk of poisoning from swallowing brake fluid. Risk of injury from brake fluid coming into contact with skin and eyes.
-
Pour brake fluid only into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling
brake fluid.
CAUTION:
-
See notes on handling brake fluid
-
See notes on repairs to brake system
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Remove rear wheels
2
Disconnect connector (X62/8) of contact sensor (S10/4)
-
Model 203 with Engine 112
-
Model 209 with Engine 112, 113
NOTE: Defective contact sensors must be replaced.
CAUTION: See notes on installing brake wear indicator contact sensors
3
Drive out retaining pin (41) using a drift (035)
NOTE: Drive in retaining pin (41) all the way using a drift.
4
Pull out brake pad (43) using lever (034)
CAUTION: Installation: Only brake pads approved by Mercedes-Benz may be fitted in sets. Brake pads should be disposed of as special
wastes. Please ask local authorities if it is permitted to dispose of these parts as household-like industrial refuse.
NOTE: Installation: Smear the side surfaces (arrows) of the brake pads (43) lightly with brake pad paste.