C 350 4MATIC (203.087) V6-3.5L (272.970) (2007)
Body Control Module: Service and Repair
AR54.21-P-1260P Remove/Install SAM With Fuse and Relay Box, Left Front
AR54.21-P-1260P Remove/Install SAM With Fuse and Relay Box, Left Front
Shown In Model 203.0
DANGER:
-
Risk of injury in the form of trapping or crushing, or even severing of limbs, if caught in windshield wiper mechanism
-
Always remove ignition key when working on windshield wiper mechanism.
1
Set wiper arms to vertical position
DANGER:
-
Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through
burns to skin and eyes from battery acid or when handling damaged lead-acid batteries
-
No fire, sparks, naked flames or smoking.
-
Wear protective gloves, acid-resistant clothing and safety glasses. Pour battery electrolyte only into suitable and appropriately
marked containers
2
Disconnect ground cable of battery
CAUTION: Do not connect quiescent current retention unit due to risk of short-circuit.
3
Unlock and remove cover (1) on module housing (4)
NOTE: Installation: Check gasket for damage
4.1 Remove injection system control module
4.2 Remove front SAM control module with fuse and relay module (N10/1) from guide.
5
Unscrew bolts (3)
6
Release and remove connectors
NOTE:
-
At top on front SAM control module with fuse and relay module (N10/1)
-
Removal: Disconnect cables from control module and fuse and relay box
-
Installation: Connect cables on control module and fuse and relay box