C 43 AMG (202.033) V8-4.3L (113.944) (1998)
DISASSEMBLY
1. Remove transmission housing at converter housing
2. Remove multiple disc clutch K1, K2 and K3
3. Remove snap ring (84b) from the inner multiple-disc carrier/clutch K1 with integrated front gear set (84) and remove internally-geared wheel
(84a)
4. Remove drive shaft with clutch K2 (100)
5. Remove needle thrust bearing (85)
6. Remove snap ring (106) from outer multiple-disc carrier clutch K2
7. Take out multiple-disc pack (105)
-
Check multiple-discs for burnt spots and wear
8. Place assembly device (076) on spring plate (103) and press until the snap ring 004) is exposed (figure A)
-
Operate assembly device with a lever press
9. Remove snap ring (104)
10. Take out disc spring (102) and pull piston (101) out of multiple-disc carrier
ASSEMBLY
1. Install piston (101) in outer multiple-disc carrier
-
Check sealing ring (101a and 101b), replace if necessary
-
The rounded off edges of the sealing rings must point outwards
2. Insert disc spring (102) and spring plate (103)
-
Insert disc spring (102) with the curvature towards the spring plate (103)