C 55 AMG (203.076) V8-5.5L (113.988) (2006)
Oil Spray Jet: Service and Repair
Remove/install oil spray nozzles (pistons)
Shown On Engine 112
Remove/install
DANGER:
-
Risk of fatal accident from vehicle slipping or toppling off the lift platform
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Remove oil pan bottom section
2
Remove oil pan top section
3
Remove oil pump
NOTE: Installation:
-
Check oil return shutoff valve is correctly seated.
-
Clean strainer of oil pump.
-
Fill oil pump with engine oil before installing so that oil is delivered when it is first started.
4
Remove oil spray nozzles (1)
NOTE:
-
If necessary, rotate crankshaft slightly at belt pulley.
-
Installation: Replace oil spray nozzles.
-
It is important to ensure that the injection pipes (3) of the oil spray nozzles (1) are not bent when being installed.
-
On Engine 112.960/961 observe version of oil spray nozzles.
Clean
5
Inspect and clean oil ducts
NOTE:
-
Blow out oil ducts in flow direction of oil with compressed air.
-
Do not use hard objects for cleaning.
6
Install in the reverse order.