CL 550 (216.371) V8-5.5L (273.961) (2008)
F.
REPLACE BACKREST MASSAGE INSERT (FRONT AND REAR SEATS)
1.
Remove cover of affected seat backrest; refer to one of the following WIS documents:
^
Front seat backrest cover (Model 216): AR91.18-P-1820SC.
^
Front seat backrest cover (Model 221): AR91.18-P-1820SX.
^
Rear seat backrest cover (Model 221): AR91.12-P-1620SX.
2.
Replace air cushion insert in affected multicontour seat backrest.
Note:
In the event of faulty parts in the front and/or rear backrest(s), the complete padding of the affected backrest(s) must be replaced.
3.
Reinstall backrest cover; refer to appropriate WIS document from step 1.
4.
Proceed to Procedure I.
G.
REPLACE FRONT SEAT BACKREST MASSAGE INSERT
1.
Remove cover of affected front seat backrest; refer to one of the following WIS documents:
^
Front seat backrest cover (Model 216): AR91.18-P-1820SC.
^
Front seat backrest cover (Model 221): AR91.18-P-1820SX.
2.
Replace air cushion insert in affected multicontour seat backrest.
3.
Reinstall backrest cover; refer to appropriate WIS document from step 1.
4.
Proceed to Procedure I.
H.
REPLACE REAR SEAT BACKREST MASSAGE INSERT
1.
Remove cover of affected rear seat backrest; refer to WIS document AR91.12-P-1620SX.
2.
Replace air cushion insert in affected multicontour seat backrest.
3.
Reinstall backrest cover; refer to WIS document AR91.12-P-1620SX.
4.
Proceed to Procedure I.
I.
INSTALL SOFTWARE FOR ALL MULTICONTOUR/DYNAMIC SEATS AND DYNAMIC PUMP
1.
Connect Star Diagnosis
2.
Install software for dynamic and/or multicontour (front and rear) seat control modules and dynamic pump.
^
Follow DAS path Control units/Seats and doors" and select the appropriate control module.
^
Select Control unit adaptations/Control unit programming."
Note:
If the "No newer control module software was found" message appears when attempting to flash the control modules, proceed to step 3.
3.
Disconnect Star Diagnosis and battery charger.