CL 550 4MATIC (216.386) V8-5.5L (273.961) (2009)
Component Identification
1
Glue felt to bottom and side (one side only) of illuminated door sill molding control unit (6) (see arrows).
2
Connect black, 33-pin coupling (5) to the illuminated door sill moldings control unit (6) and insert illuminated door sill moldings control unit (6)
into bracket.
3
Route supply wiring harness (7) along on-board wiring harness over the right rear wheel well up to the cable duct to the passenger compartment
and fix in place with cable ties.
Do not damage supply wiring harness (7) by squeezing or pinching it.
4
Connect ground branch-off line of supply wiring harness to ground (right rear wheel well) (W54).
Do not damage supply wiring harness by squeezing or pinching it.