CL 550 4MATIC (216.386) V8-5.5L (273.961) (2009)
/v8-5.5l_(273.961)/Page-214035.png)
The measuring set is designed in such a way, that the measuring bolts, according to the measuring points at the vehicle, can be screwed together out of
mounting bolts, extensions and measuring tips/bolts.
The configuration of the measuring bolts is shown in the table, where the digits in the column headed "Measuring bolt configuration" are the special
tool end numbers.
For example: 02/08/10 = 168 589 07 63 02 (support stud) 168 589 07 63 08 (extension) 168 589 07 63 10 (measuring tip)
Component Identification
1
Measure distance dimension (V1) from check point (K) to center of Torx(R) bolt head of rear mount of front axle carrier. Measure on the left and
right side in each case.
If necessary, unscrew and screw in Torx(R) bolts and check for deformation.
Shown on model 221
Component Identification
