CL 550 4MATIC (216.386) V8-5.5L (273.961) (2009)
2. Check back end of transmission line (arrow, Figure 2):
-
Support transmission tail shaft with under-lift floor jack then remove transmission cross member.
-
Disconnect back end of transmission line (arrow, Figure 2).
NOTE: Use long handled 3/8 inches ratchet to remove transmission line bolt.
-
If there is a restrictor (B, Figure 2) installed in the back end of the transmission line (arrow): Installation is correct - procedure is complete
(reassemble in reverse order).
-
If there is no restrictor (B, Figure 1) installed in the line: Installation of restrictor is INCORRECT. Stop and replace transmission. Please
submit a WSG pre-authorization form for approval. Please enter key word: "Restrictor". Submit transmission replacement under normal
warranty.
NOTE:
The following allowable labor operation should be used when submitting a warranty claim for this repair:
Warranty Information
Operation: Inspect both ends of transmission line for restrictor (27-0000)
R and R lower engine panel (61-1087).
NOTE:
Replacement of the transmission requires a separate line of repair and should not be included in the C1 Action claim.