CL 600 (140.076) V12-6.0L (120.982) (1998)
/v12-6.0l_(120.982)/Page-630003.png)
7
Push end cover (14) together with radial seal (15) over the screwed-on inner part of insertion too] (6) 117 589 00 43 00 and screw on.
Do not damage oil pan gasket (arrows); to avoid this, bit end cover (14) back slightly at the top when fitting on. If necessary, replace oil pan
gasket.
8
Install bolts according to bolt diagram.
9
Tighten front cover bolt (1 and 2) first of all. Tightening torque 9 Nm.
TIGHTENING TORQUE
SPECIAL TOOLS
