CL 600 (140.076) V12-6.0L (120.982) (1998)
Engine Mount: Service and Repair
Removing and Installing Engine Mount
PRECEDING WORK
Air cleaner with mass air flow sensor removed.
OVERVIEW
Ground cable at battery:
Disconnect, connect.
Fan cowl ring:
Remove, place over fan, fit on.
Installation note
4 catch points:
Ensure correctly located.
Bottom engine compartment panel (2):
Remove, install.
Bolts (1) at front axle:
Unscrew, screw on (25 Nm).
Drag link:
Remove, install.
Right engine oil cooler line at cooler cross member:
Detach.
Engine at front lifting eye:
Raise, lower.
When raising engine pay attention to coolant hoses.
Left engine mount: secondary air injection line:
Unbolt at cylinder head and at crankcase, bolt on.
Installation note
Gasket, note.