CL 600 (140.076) V12-6.0L (120.982) (1998)
/v12-6.0l_(120.982)/Page-683003.png)
7
Tighten installation sleeve 119 589 01 14 00 against stop with bolt (1) and 4 plate springs (2).
The shaft seal (8) must be at right angles to the hub to assure a perfect seal.
8
If wear grooves are present on the hub, install shaft seal (8) offset 3 mm inward. For this purpose, attach shaft seal (8) to side b of installation
sleeve 119 589 01 14 00 and tighten against stop in aligned position.
9
Install pulley/vibration damper.
10
Allow engine to run, check for leakage
SPECIAL TOOL
