CL 600 (215.378) V12-5.8L (137.970) (2002)
Sunroof / Moonroof Interior Trim Panel: Service and Repair
AR77.20-P-1000M Remove/Install Sliding/Pop-Up Roof Panel
AR77.20-P-1000M Remove/Install Sliding/Pop-Up Roof Panel
1
Push cover on sliding roof to rear
2
Open sliding/pop-up roof approx. 10 cm
3
Remove molding (2)
-
Installation Wedge: See "Special Tools" below.
NOTE: Before pulling off press off molding (2) on outside with plastic wedge (see arrow)
4
Move sliding/pop-up roof to pop-up position
5
Remove rail (3) on rubber bellows (4) in direction of arrow
CAUTION: Unclip rail (3) at front first
6
Unhook rubber bellows (4) on sliding/pop-up roof panel (1) so that Torx screws (5) are accessible
CAUTION: Do not damage rubber bellows (4)
7
Unscrew Torx screw (5)
-
See "Special Tools" below.
-
Screw for sliding/pop-up roof panel on titling bracket mount: 4 Nm
8
Unclip and disconnect connector (6) from frame for sliding/pop-up roof (1) with installation wedge
-
See "Special Tools" below.
CAUTION: Do not damage frame for sliding/pop-up roof (1). Do not pull on cable to disconnect connector (6)
9
Remove sliding/pop-up roof panel (1)
10
Install in opposite order
11
Adjust sliding/pop-up roof panel (1) in relation to outer roof surface and tighten Torx screws (5).
Special tools