CL 600 (215.378) V12-5.8L (137.970) (2002)
Fuel Filter: Service and Repair
Replace Fuel Filter
Shown On Model 220.176
Remove/Install and replacing
DANGER:
-
Lethal injuries are possible if vehicle slips off of lifting platform
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by
the vehicle manufacturer.
-
Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from
contact with fuel.
-
Fire, sparks, open flames or smoking forbidden.
-
Pour fuels only into suitable and appropriately marked containers.
-
Wear protective clothing when handling fuel.
1
Release pressure in fuel tank
NOTE: For this step open fuel filler flap (1) and filler cap (2) and reseal.
2
Remove cover (3) of fuse pump assembly
NOTE: Installation: Install cover (3) only after check for leaks.
3
Pinch-off fuel hoses (4)
NOTE: Installation: Inspect condition of fuel hoses (4) and hose clamps, replace if necessary. Only use hose clamps mentioned in the electronic
power control.
-
Clamp: See Special Tools below.
-
Clamping pliers: See Commercially Available Tools below.
4
Disconnect fuel hoses (4) at fuel filter (5)
NOTE: Collect fuel which flows out.