CL 600 V12-58L (137970) Alignment Check - Service and Repair
Shown On Model 220 With Airmatic
Eccentric Rubber Mount
1
Check vehicle level at front and rear axle with electronic inclination meter and adjust, if necessary
2
Adjust toe-in with cam bolt (60a) at the mount of the left and right tie rod (60) at the rear axle carrier
NOTE:
-
If the test values are not achieved, the rubber mount installed as standard (60b) can be replaced by an eccentric rubber mount (60c).
-
The offset of 1.5 mm makes it possible to decrease the toe-in by 15 inch (Fig. A) or to increase the toe-in by 15 inch (Fig. B).
AR40.30-P-0401I Preparations For Distance/Comparison Measurements
Preparations For Distance and Comparison Measurements