CLK 320 (208.365) V6-3.2L (112.940) (1999)
Part 3 Of 3
Removal
NOTE:
^
Refer to Notes On Brake Fluid. See: Service Precautions/Vehicle Damage Warnings
^
Refer to Notes on Test and Repair Work to brake system. See: Service Precautions/Vehicle Damage Warnings
1. Ignition OFF.
2. Disconnect hydraulic lines.
-
Seal hydraulic lines and connections with blind plugs.
CAUTION: Do not transpose lines.
3. Remove hydraulic unit.
-Model 170, pull upward out of the rubber plugs.
Installation
Reverse procedure to install, noting the following:
-
Install plastic caps with lugs downward.
-
Tighten lines to hydraulic unit to: 15 Nm
-
Bleed brake system. See: Brake Bleeding/Service and Repair
-
Read and clear any Diagnostic Trouble Codes (DTC)s.