CLK 320 (208.365) V6-3.2L (112.940) (1999)
Parking Brake Cable: Service and Repair
AR42.20-P-0525A Remove/Install Rear Brake Control Cable
NOTE: For model name/model number cross reference refer to Model Designation Table. See: Application and ID
Removal
1. Remove, install parking brake shoes, refer to Replacement. See: Parking Brake Shoe/Service and Repair
2. Detach return spring (94).
3. Model 129 or 170, loosen adjustment screw (89).
4. Detach front brake cable (85) on intermediate lever (91).
-
Model 129 or 170, replace self-locking bolt (93).
5. Detach brake control cables (86) on compensating lever (92).
6. Detach brake control cables (86) on frame floor.
-
Models 170, 202 or 208, use clip remover tool No. 210 129 589 11 63 00 (043).
-
The brake control cable can also be removed by destroying the clamping ring (84).
7. Unscrew self-locking bolt (98) on wheel carrier.
8. Remove brake control cable (86).
Installation
9. Install in reverse sequence, noting the following:
-
To install brake control cable if clamping ring was destroyed during removal, insert new clamping ring into the groove of the brake control
cable
-
Replace self-locking bolt (98).
-
Tighten self-locking bolt of brake control cable at rear wheel carrier to: 20 Nm