CLK 320 (208.365) V6-3.2L (112.940) (1999)
Ready Screen For Angle 2
The display then indicates Ready for next measurement for angle 2.
8
Remove sensor (020a) from transmission.
Ready screen for angle 2
Installation, only vehicles with automated manual transmission (ASG)
9
Remount the hydraulic pump cover on the left side of the transmission (vehicles with gasoline engine).
10
Remount the cover above the plug-in connection on the right side of the transmission.
When installing cover, insert lug at the top.
AR41.10-P-0085-03P Measure Absolute Angle at Rear Axle Housing
AR41.10-P-0085-03P Measure absolute angle at rear axle housing
Measurement -Angle 4
The vehicle must be on its wheels for the measurement.
All four angles should be measured in succession without interruption.
An angle that has already been measured can be measured a second time if required. To do this, with the Measurement menu displayed, press the
STEP button repeatedly until the display indicates Ready to measure the relevant angle.
Component Identification
1
Clean contact surfaces (arrows) at rear axle housing to remove paint and/or gasket residuals and remove uneven material using a suitable tool.
Shown on model 203, 209