CLK 320 (208.365) V6-3.2L (112.940) (1999)
Drive/Propeller Shaft: Removal and Replacement
AR41.10-P-0200DA Replacing Centering Sleeve
Replacing Centering Sleeve
1
Remove propeller shaft
2
Mark flexible disks (12,12a) relative to two-arm or four-arm flange and detach
NOTE: Installation: Check flexible disk for damage and replace if necessary
CAUTION: Replace self-locking nuts
3
Loosen fitted sleeves of flexible disks
4
Detach vibration damper (20) from front propeller shaft
NOTE: Installation: Fit vibration damper and propeller shaft as per the applied marking
5
Mark vibration damper relative to rear propeller shaft and detach
NOTE: Installation. Fit vibration damper as marked
6
Separate front and rear propellor shaft at clamped joint or slide
NOTE: Installation: Smear splined shaft profile with Molykote grease
7
Check centering sleeve in front and rear propellor shaft
NOTE: If the sealing lip in the centering sleeve (10) is worn or damaged, the centering sleeve can be replaced individually.
8
Remove centering sleeve (10)
-
If necessary after checking
NOTE: Installation: press in centering sleeve (press-in distance of centering sleeve)
9
Pack cavities in the two centering sleeves with grease
10
Install in reverse order
AR41.10-P-0050EA Remove/Install Propeller Shaft
Removing And Installing Propeller Shaft