CLK 320 (209.365) V6-3.2L (112.955) (2004)
/v6-3.2l_(112.955)/Page-806001.png)
Coolant: All Technical Service Bulletins
Campaign - Coolant Strength Inspection
FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER
Campaign No. 2005090016
October 2005
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT:
MODELS 203/209 MODEL YEAR 2004
CHECK COOLANT STRENGTH AND ADJUST IF NECESSARY
This Service Campaign has been initiated because DCAG has determined that on the affected vehicles (see VIN range below) the antifreeze content may
not be sufficient. Dealers will check the strength of the antifreeze and add additional coolant as necessary.
Please review the Effective Serial Number chart located below and if necessary repair the subject vehicles during the vehicle's next service.
Prior to performing this Service Campaign:
^
Please check VMI to insure the vehicle is involved and to determine if the vehicle has been previously repaired.
^
Please review the entire Service Campaign bulletin.
Approximately 191 vehicles are affected.
Effective Serial Number Range
Note:
Every vehicle in the VIN range may not be included in the campaign. VMI must always be checked before performing campaigns to verify that the
campaign is required on a specific vehicle. VMI always overrides the bulletin in reference to a specific vehicle's inclusion in a particular campaign.
Please also note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Procedure
WARNING!
^
Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray.
^
Do not open cooling system if engine coolant temperature is above 90°C. Wear protective clothing, gloves and eye protection.
^
When opening cooling system (removing pressure cap), turn cap slowly to allow gradual pressure release.
1.
Check coolant strength:
