CLK 320 Cabriolet (208.465) V6-3.2L (112.940) (2000)
1
Remove pushbutton control module
2
Remove cover (2) in center console
3
Remove heater and automatic temperature control and operating unit and lay down to side together with disconnected wiring harness
4.1 Remove radio and navigation operating control module (APS)
4.2 Pull out COMAND control module
5
Open armrest cover
6
Open cup holder cover
7
Open ashtray cover
8
Unclip cover (3) from shift lever using long wedge
See "Special Tools" given below.
9
Unclip cover (4) and remove
10 Unscrew screws (5) from cover frame (1)
11 Unclip catches (arrows) from cover frame (1) on center console on both sides with puller hook
-
For this purpose position puller hook below cover frame pull upward and unclip single catches (arrow) one after another
See "Special Tools" given below.
NOTE: Installation: Clip single catches (arrows) on cover frame (1) first at left and then at right from top to bottom while simultaneously
folding back rear cover to rear (bent arrows)
12 Unhook lugs (6) with puller hooks
See "Special Tools" given below.
13 Remove cover frame (1) upward
NOTE: Installation: When positioning cover frame fold back cover to rear in area of lugs (6)
14 Install in the reverse order
Special Tools