CLK 320 Cabriolet (208.465) V6-3.2L (112.940) (2000)
CAUTION:
-
Installation: Install camber strut, tension arm, torque strut, track rod and spring link at wheel carrier
-
The rear axle shaft must be horizontal when tightening the nuts.
NOTE: Removing and installing brake shoes of parking brake
2
Camber strut
2H Sleeve in wheel carrier to reduce diameter
3
Torque strut
3H Sleeve in wheel carrier to reduce diameter
4
Remove/install track rod
5
Torque strut
5h
Sleeve in wheel carrier to reduce diameter
-
Install sleeve for torque strut in wheel carrier
6
Spring link
7
Wheel carrier
-
Remove front rear axle shaft
12
Remove/install and secure rear axle shaft twelve-point collared nut
37
Remove/install
-
Pull out of rear axle shaft flange
-
If the rear axle shaft is difficult to remove. Push rear axle shaft out of rear axle shaft flange, pull in.
Remove/install rear brake control cable
112c Brake caliper dust shield
L6/3, L6/4 Remove/install left or right rear axle speed sensor
AR35.20-P-0116-01B Remove/Install Supporting Joint on Wheel Carrier
AR35.20-P-0116-01B Remove/install supporting joint on wheel carrier
Special Tools