CLK 320 Cabriolet (208.465) V6-3.2L (112.940) (2000)
Flex Plate: Service and Repair
AR03.30-P-8001C Remove/Install Flywheel/Driven Plate
Remove/Install Flywheel/Driven Plate
Shown On Engine 112
DANGER:
-
Risk of death, Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by
the vehicle manufacturer.
1.1 Remove automatic transmission
1.2 Remove manual transmission
2
Install retaining lock (6)
3
Dismount clutch
4
Unscrew bolts of flywheel (3) from crankshaft (5)
CAUTION: Installation: Install new bolts for flywheel (3), because the connection may become loose if reused or the bolts of the flywheel (3)
may break off.
5
Remove washer (2).
6
Remove flywheel with starter ring gear (1) or drive plate
NOTE: Installation: The cylindrical pin (4) determines the installation position.
7
Install in the reverse order
8
Carry out initialization
NOTE: If a new flywheel is installed, perform initialization in the ME control module with STAR Diagnosis in the menu point "Control module
adaptation".