CLK 350 Cabriolet (209.456) V6-3.5L (272.960) (2006)
/v6-3.5l_(272.960)/Page-3706003.png)
13. Position molding strip on bumper and check retaining spring (4) for easy motion.
14. If necessary leave bumper open according to drawing until retaining spring (4) and installation housing (7) have sufficient clearance (see arrows).
15. Install molding strip in bumper.
16. Insert impact absorber into bumper.
17. Install inner bumper section (21).
18. Insert wiring harness for ultrasonic sensors (10) into the inner section of the bumper (21), whereby the 6-pin coupling of the rear bumper PTS
connector (X35/28) must be positioned on the right in the direction of travel.
19. Connect the connectors of the wiring harness for ultrasonic sensors (10) to the individual sensors and pull the decoupling ring (6) onto front side of
sensors (5) (see figure section).
20. Insert the sensor (5) into the installation housing (7) until the lugs on the sensor (5) lock in position audibly in the installation housing (7).
Sensor connections (5) point away from the middle axis of the bumper.
21. Remove existing grommet (arrow) on the right side of the vehicle.
Part no longer required.
22. Guide the wiring harness for ultrasonic sensors (10) with 6-pin coupling through the conduit (see arrow) and seal with grommet on the wiring
harness.
