CLK 350 Cabriolet (209.456) V6-3.5L (272.960) (2006)
3.
Unhook mesh panel (Figure 4) at rear and loosen Velcro fastening along the lower edge.
4.
Detach gas spring at upper end (Figure 5, arrow).
5.
Remove 2 screws on each side fastening the front of the partition panel (Figure 6, arrows) in place.
6.
Remove roof block (Figure 4, arrow) and trim panel.
7.
Disconnect line 15 (Figure 7, arrow) from master cylinder. Access will be easier if the rod end of the cylinder is disconnected.