mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

P-27_00-95 > < Engine Controls - Code 061B After Reprogramming
Page 1
background image

Control Module: All Technical Service Bulletins
A/T Controls - TCM Flashing Tip

Date: April 18, 2007

Order No.: P-B-27.19/98

Group: 27

SUBJECT:
Model 209.356/372/375/456/472/475/477

Equipped with 722.9 transmission (7G-Tronic)

Flashing Process for Transmission Control Module Executed Incorrectly / Not at All

If you are experiencing difficulties flashing the transmission control module in the above model vehicles, the issue may be  that the electronic ignition
switch (EIS) erases CAN frames at high bus loads.

To resolve this issue on the following affected EIS part numbers, remove the fuses of the engine control unit (N10/1f48,  N10/1f53, N10/f54) and ESP
control unit (N10/1f56) from the front SAM control unit (N10/1) during the flashing procedure.

A209 545 11 08

A209 545 13 08

A209 545 12 08

A209 545 14 08

P-27_00-95 > < Engine Controls - Code 061B After Reprogramming