CLK 430 (208.370) V8-4.3L (113.943) (1999)
a) Press start button for 2 to 4 seconds (DTC appears)
b) Wait 3 seconds, then press start button for 6 to 8 seconds, thereby erasing the previously displayed DTC from memory.
c) Each stored DTC must be erased individually.
1) Erasing of stored diagnostic trouble codes must begin within 20 seconds of reading the DTC. After 20 seconds, the DTC can no longer be erased.
Erasing procedure can be restarted by performing DTC memory readout after the fault is again displayed.
Special Tools
38-pole Data Link Connector (X11/4)
Connect impulse counter scan tool as follows:
Red wire (circuit 30, voltage):
socket 3
Black wire (circuit 31, ground):
socket 1
Yellow wire to diagnostic output socket of the system being tested.
[i]
Please see below for connection and use of HHT.
013
Impulse counter scan tool
075
Adaptor for impulse counter scan tool
087
Hand-Held Tester (HHT)
094
Multiplexer, 965 589 00 40
X11/4
Data link connector