CLK 430 (208.370) V8-4.3L (113.943) (1999)
Oil Filter Housing: Service and Repair
Remove/Install Oil Filter Housing
Shown On Engine 112 Without Air Pump
1
Remove engine trim panel or air cleaner
NOTE: Detach engine cover or air cleaner by lifting vertically up and off the cylinder head covers.
2
Remove viscous fan (1)
NOTE: Right-hand thread!
3
Remove fan shroud (2).
NOTE: On model 163 unscrew bolts at bottom of fan shroud.
4
Unscrew cap (4) at oil filter housing (5)
5
Unscrew bolts (9) of oil-water heat exchanger (3) at oil filter housing (5)
NOTE: Do not pinch off coolant lines.
6
Unscrew bolt (8) at oil filter housing (5)
7
Remove oil filter housing (5)
NOTE: Installation: Replace seal (6).
8
Install in the reverse order
9
Check engine oil level
NOTE: All except engine 112.912 /946.