CLK 430 (208.370) V8-4.3L (113.943) (1999)
Ignition Lock Cable: Service and Repair
Removing and installing ignition lock control cable
Removing, installing
1
Disconnect ground cable of battery
2
Remove ashtray at front of center console
3
Remove bottom section of instrument panel on driver's side
4
Press locking tabs (1a) together and push ignition lock cable (1) out of ignition/starter switch (N73) in the direction of the arrow
CAUTION: Installation: Turn ignition lock to position "O".
Function test:
-
It must only be possible to move the selector lever out of position "P" when the ignition lock is in position "2" and the brake pedal is
depressed.
-
It must only be possible to withdraw the ignition key when the ignition lock is in position "2".
5
Unclip ignition lock cable (1) from electronic selector lever module (N15/5)
NOTE: Press locking tab (1b), twist coupling (1c) through 90 degrees in the direction of the arrow and pull off ignition lock cable (1).
6
Remove ignition lock cable (1) from dashboard
7
Install in the reverse order