CLK 430 (208.370) V8-4.3L (113.943) (1999)
Shifter A/T: Removal and Replacement
Removing and installing electronic selector lever module (ESM)
Removing, installing
1
Unhook shift rod at intermediate lever (3) by, removing the clip locking device
NOTE: If performing any adjustment work: Adjust shift rod.
2
Remove center console
3
Remove insulation mat
-
Model 163.
4
Unclip ignition lock control cable (1) from electronic selector lever module (N15/5)
NOTE: Press locking tab (1b), twist coupling (1c) through 90 degrees in direction of arrow and pull off ignition lock control cable (1).
CAUTION: Installation: Switch ignition lock to position "O".
Function test:
-
It must only be possible to move the selector lever out of position "P" when the ignition lock is in position "2" and the brake pedal is
depressed.
-
It must only be possible to withdraw the ignition key when the selector lever is in position "P".
5
Unscrew Alien bolts (2)
6
Disconnect selector lever position plug connector (5)
7
Remove electronic selector lever module (N15/5)
CAUTION: Cannot be disassembled.
NOTE: Installation: Check gasket (4) for correct installed position and condition, replace if necessary.
8
Install in the reverse order
NOTE: After installing the electronic selector lever module, read out the fault memory with STAR DIAGNOSIS.