CLK 430 Cabriolet (208.470) V8-4.3L (113.943) (2000)
Wheel Hub: Removal and Replacement
AR35.20-P-0130-01B Pulling Out and Drawing In Rear-Axle Shaft Flange (Wheel Carrier Installed)
AR35.20-P-0130-01B Pulling out and drawing in rear-axle shaft flange (wheel carrier installed)
Special Tools
Special tool assignment:
Models 129, 140, 163, 170, 202, 203, 208, 209, 210, 215, 220:
Extraction tool 202 589 04 43 00
Models 129, 140, 163, 170, 202, 203, 208, 209, 210, 215, 220:
Pressure screw 202 589 04 43 11
Models 140, 163, 210.2/6, 215, 220:
Extraction and installation tool 1 40 589 08 43 00
Models 129, 170, 202, 203, 208, 209, 210.0:
Extraction and installation tool 124 589 05 43 00
Component Identification
Pull out rear axle shaft flange
1
Insert threaded bolt (010j), part 03, through rear axle shaft flange (10) from the inside and bolt on bracket (010g).
2
Lay support plate (010d) (depending on model) on face of wheel carrier (7).
3
Pass pressure plate (010f) with thrust pin (010b) through bracket and lay on support plate (010d).