CLK 500 (209.375) V8-5.0L (113.968) (2003)
6
Remove rubber boot (37I) from opposite constant velocity joint
-
Only if necessary
NOTE: The boot (371) can be removed over the rear axle shaft (37a)
7
Check constant-velocity joint for wear
NOTE:
-
Refer to Dismantling constant-velocity joint inspecting for wear, assembly
-
If the outer constant velocity joint is defective, the rear axle shaft (37a) must be replaced
8
Install in the reverse order
AR35.30-P-0660-01AF Installing End Cover and Cup Seal on Joint Ring
AR35.30-P-0660-01AF Installing end cover and cup seal on joint ring
- Bolted rear axle
Rear axle shaft
Rear axle shaft