CLK 550 (209.372) V8-5.5L (273.967) (2008)
/v8-5.5l_(273.967)/Page-3196001.png)
Front Bumper: Procedures
AZ88.00-P-0001-02QA Converting Front Bumper
- as of 1.6.05
Modification Notes
Do not damage paint.
1. Clean holes for center air inlet grate mounting clips.
Remove paint residues present with 7.2 mm dia. bit or awl
2. Insert mounting clips (2) for center air inlet grate into cleaned holes (6 each).
The openings of the mounting clips (2) should point in the direction of travel.
Component Identification
3. Hook in retaining strap covers (3) for mounting screw covers.
Install components in correct positions. The end with the stay (see arrow) is intended for hooking in the mounting screw cover. Hook in and close
mounting screw covers after installing the bumper.
