CLK 550 (209.372) V8-5.5L (273.967) (2008)
3
Disconnect ground cable of battery
4
Remove entire steering column module (N80) with combination switches and clock spring contact (A45)
5
Remove bottom section of dashboard on driver's side
6
Remove left front floor covering
7
Remove air duct (1)
8
Remove jacket tube from instrument panel carrier and fold down into footwell
NOTE: Do not remove bottom steering shaft from steering coupling.
Refer to Remove/install jacket tube.
9
Detach tensioning springs (2)
10
Remove connection (3)
11
Pull out socket yokes (4) for heating water pipes (5)
NOTE: Installation: Install new socket yokes.
12
Pull out heating water pipes (5)
CAUTION: To avoid contamination of the interior caused by coolant, close heating water pipes (5) and heat exchanger openings (8).
NOTE: Installation: Install new sealing rings.
-
See "Special Tools" given below.
13
Unscrew bolts (6)
14
Remove bracket (7)
15
Pull out heat exchanger (8)
CAUTION: Clean AC/heater housing from inside, if necessary remove escaping coolant.
16
Install in the reverse order
17
Check for proper function.
Special Tools
Set of Plugs, P/N# 129 589 00 91 00