mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

GF27.10-P-0001-04PZ Automatic Transmission (AT), Location of Components, Floor Shift|Page 8595 > < GF27.10-P-0001-04PZ Automatic Transmission (AT), Location of Components, Floor Shift|Page 8593
Page 4
background image

GF27.60-P-2000RMZ Gear Shift, Function

GF27.60-P-2000RMZ Gear shift, function

- TRANSMISSION 722.6
- 209.376 as of 1.6.03
- 209.476
- 211.076 as of 1.9.03
- 211.276
- 219.376
- 230.474 as of 1.9.03
- 230.479 up to 08

On transmission 722.6 the electrohydraulic control unit converts the electric signals going out from the electronic transmission control (EGS) into
hydraulic signals.

Faults occurring in the ETC control unit (N15/3) are handled by the limp-home system. This is designed to allow the driver to reach a service outlet
even under extreme conditions.

In parallel with being conveyed via the controlled area network bus class C (engine compartment )(CAN-C), the selector lever positions "P", "R", "N"
and "D" are passed on mechanically by means of a shift rod mechanically to the range selector lever at the transmission side.

Program selection "C/S"

Via touching or holding the selector lever towards "+" or the shift range is preselected and displayed in the instrument cluster (A1) until an upshift of
the transmission 722.6 is possible.

Program selection "M"

Program selection "M" is only possible in selector lever position "D". In the process the 5 forward gears of transmission 722.6 can be shifted direct,
either via the steering wheel gear shifter MINUS (S110/1), steering wheel gear shifter PLUS (S111/1) or via the selector lever.

The shifted gear is displayed in the instrument cluster (A1). The transmission automatically changes into the sport program "S" when the selector lever
is shifted out of selector lever position "D". Shift processes at unacceptably high or low engine speed are not carried out.

In addition a mandatory downshift occurs at too low an engine speed or a mandatory upshift occurs at too high an engine speed. When the vehicle is
stationary the transmission automatically shifts into 1st gear. It is possible to start off both in 1st or 2nd gear.

GF27.60-P-5100-03PZ Center Shifter Console, Design

GF27.60-P-5100-03PZ Center shifter console, design

- TRANSMISSION 722.6
- 209 as of 1.6.03
- 211 as of 1.9.03
- 219

GF27.10-P-0001-04PZ Automatic Transmission (AT), Location of Components, Floor Shift|Page 8595 > < GF27.10-P-0001-04PZ Automatic Transmission (AT), Location of Components, Floor Shift|Page 8593