CLK 55 AMG Cabriolet (209.476) V8-5.5L (113.987) (2006)
NOTE:
-
This does not apply to vehicles with different tires of varying specifications on the front and rear wheels.
-
Depending on the extent of wear after a distance of between 5,000 and 10,000 km.
9
Push on wheels and tighten wheel bolts
-
All except model 210 with special protection version code (979)
10
Lower the vehicle, correct tire pressure of all wheels and fit wheel covers
NOTE:
-
If there is a loss of tire pressure: determine cause and replace the tire if necessary.
-
On vehicles with tire pressure monitor code (475): Only use plastic valve caps (risk of corrosion).
11
Fit wheel covers
12.1 Correct tire pressure of spare wheel
-
Vehicles with spare wheel
NOTE:
-
If there is a loss of tire pressure: determine cause and replace the tire if necessary.
-
On vehicles with tire pressure monitor code (475)
-
Only use plastic valve caps (risk of corrosion).
12.2 Check expiry date of TIREFIT tire sealant TIREFIT tire sealant
-
Vehicles with TIREFIT
13
Activate tire pressure monitor
-
On vehicles with tire pressure monitor code (475), Only when replacing a wheel, changing tires or altering the tire pressure.
AZ40.10-P-0001-03A Removing Standard Wheels
AZ40.10-P-0001-03A Removing standard wheels
1
Loosen wheel bolts
2
Lift vehicle
3
Unscrew wheel bolts
When unscrewing the last wheel bolt, ensure that the wheel does not tilt off the hub in an uncontrolled manner.
4
Remove wheel
For driving with the spare wheel, refer to the Owner's Manual.
AZ40.10-P-0001-01K Wheel / Tire Combinations
AZ40.10-P-0001-01K Wheel / tire combinations
Information on newly added tire approvals can be found in the current certificate and current Service Information "Summer tires in combination with
AMG special equipment and AMG light-alloy wheels from the accessories program".
Take unidirectional tires into account when fitting.
Information on the operation of snow chains can be found on the current certificate.
AZ40.10-P-0001-03B Removing Standard Wheels
AZ40.10-P-0001-03B Removing standard wheels
1.1 Remove hubcaps from steel disk wheels.
2
Slacken wheel bolts.
3
Raise vehicle.
4
Unscrew wheel bolts.
When unscrewing the last wheel bolt, make sure that the wheel does not tip off the hub out of control.
5
Remove wheel.
If steel disk wheels were previously installed 5 of the removed standard wheel bolts must be kept with the spare wheel. The standard spare wheel can