CLK 55 AMG Cabriolet (209.476) V8-5.5L (113.987) (2006)
Special Tools
Special tool assignment:
Models 129, 140, 163, 170, 202, 203, 208, 209, 210, 215, 220:
Extraction tool 202 589 04 43 00
Models 129, 140, 163, 170, 202, 203, 208, 209, 210, 215, 220:
Pressure screw 202 589 04 43 11
Models 140, 163, 210.2/6, 215, 220:
Extraction and installation tool 1 40 589 08 43 00
Models 129, 170, 202, 203, 208, 209, 210.0:
Extraction and installation tool 124 589 05 43 00
Component Identification
Pull out rear axle shaft flange
1
Insert threaded bolt (010j), part 03, through rear axle shaft flange (10) from the inside and bolt on bracket (010g).
2
Lay support plate (010d) (depending on model) on face of wheel carrier (7).
3
Pass pressure plate (010f) with thrust pin (010b) through bracket and lay on support plate (010d).
4
Position hydraulic auxiliary press (010h) between thrust washer (010f) and bracket (010g). Unscrew pressure screw (010k) on hydraulic auxiliary
press and then screw in bolt (1st version) or hand wheel (2nd version, 010i) of bracket until it rests on the pressure cylinder of hydraulic auxiliary
press.