E 300 (124.131) L6-3.0L DSL (606.910) (1995)
/l6-3.0l_dsl_(606.910)/Page-814004.png)
check lip seals (16, 17) and replace if necessary. Lip seals must be installed in such a way that sealing lip is facing downwards (direction of arrow).
Fit insertion sleeve (024) onto front cover (10). Lubricate sliding surfaces for lip seals.
Lubricate lip seals at piston. Insert piston (12) in such a way that the stud (on piston) and the hole (1n front cover) are aligned. Press down piston
carefully without tilting it; if necessary, move it down by pressing a pin against the outer lip seal (arrow). Take off insertion sleeve (024).
6. Loosen bolts (8) and unscrew.
7. Remove primary pump from front cover.
Installation Note
Insert M8 x 32 bolts (8) and tighten to 20 Nm.
Note:
