E 320 4MATIC Sedan (210.082) V6-3.2L (112.941) (1999)
/v6-3.2l_(112.941)/Page-1911004.png)
-
Hexagon bolts of propeller shaft intermediate bearing on frame floor: 30 Nm
-
Self-locking bolt for front reinforcement on frame floor: 25 Nm
-
Nut for bracket seat belt fastening to frame floor: 280 Nm
AR41.10-P-0200A Replacing Centering Sleeve
Replacing Centering Sleeve
REMOVAL
1. Remove propeller shaft.
2. Mark relative positions of flexible disks (12) to three-arm flange and remove
3. Using a suitable shop made drift, loosen fitted sleeves in flexible disks
4. Separate front and rear propeller shafts, if necessary
-
Note position of alignment marks (raised humps) on shafts, place matchmarks if required.
5. Check centering sleeve (10) in front and rear propeller shafts
-
If sealing lip in centering sleeve (10) is worn or damaged, the centering sleeves can be replaced individually
6. Remove centering sleeve (10) as follows:
