E 320 4MATIC Sedan (211.082) V6-3.2L (112.954) (2004)
Sunroof / Moonroof Cable: Service and Repair
AR77.20-P-1400T Remove/Install Cable
AR77.20-P-1400T Remove/Install Cable
- with CODE (414) Power glass tilting/sliding roof
Shown On Model 211.0
1
Remove sliding/pop-up roof panel
2
Remove overhead control panel control module
NOTE: Leave sliding/pop-up roof panel in pop-up position.
3
Remove sliding/pop-up roof motor
NOTE: Installation:Before installing sliding/pop-up roof motor, push pop-up brackets (4) forward as far as the stop.
4
Remove water drain channel (1) with long wedge (2)
See "Special Tools" given below.
5
Unscrew bolt (3) on both sides from control cable (7) on pop-up bracket (4)
6
Push pop-up bracket (4) on both sides approx.6 cm toward rear
7
Unscrew bolts (6) on both sides from cover (5), detach cover (5) toward top on both sides
8
Push control cable (7) on both sides approx.10 cm toward rear
9
Remove control cable (7) on both sides from slide rail and pull out toward rear.
CAUTION: Pull out cable (7) carefully, otherwise paintwork could be damaged.
10
Install in the reverse order
Special Tools