E 320 4MATIC Sedan (211.082) V6-3.2L (112.954) (2004)
6.
When the "Control Unit Adaptations" menu item is selected the parameters are updated and SDS checks whether the SBC control module requires
programming.
^
If programming is not required, a white Q11 sticker must be affixed to the pump motor of the SBC hydraulic unit in a clearly visible position.
The sticker must be applied to a clean surface. Disconnect SDS from vehicle. The vehicle can be returned to the customer.
^
If SDS indicates that control module software for updating has been found, continue with step 6.
^
Ensure that the vehicle has an adequate power supply (more than 12.5V) using a battery charger. Do not connect the negative terminal of the
battery charger to the vehicle battery, but connect it to a vehicle ground instead.
^
Read and observe notes on control unit programming in DAS.