E 320 4MATIC Sedan (211.082) V6-3.2L (112.954) (2004)
Electronic Brake Control Module: All Technical Service Bulletins
ABS/TCS - Programming Of SBC Control Unit Aborted
SBC control unit cannot be programmed: Fault code P1 F100 K3 E50 T0 U0 is displayed in XENTRY DAS
Topic number
LI42.46-P-049107
Version
1
Design group
42.46 Sensotronic Brake Control (SBC)
Date
03-11-2010
Validity
Model 211/219 with SBC (up to code 806)
Model 230
Reason for change
Reason for block
Complaint:
Programming of the SBC control unit is aborted at 20% progress.
In XENTRY DAS the message "An error occurred during control unit programming"" appears and fault code P1 F100 K3 E50 T0 U0 is displayed.
Cause:
The serial data link between Star Diagnosis and the SBC module is disrupted.
Possible causes:
1. 9-pin adapter cable is damaged.
2. 9-pin connector of SBC module is damaged.
3. 9-pin connector of Star Diagnosis unit is damaged.
Remedy:
Follow menu guidance in DAS.
Reference S-B-58.00/151b
1. Replace 9-pin adapter cable if necessary.
Note:
Do not use serial cables from the computer accessory retail trade!
2. Check 9-pin connector on SBC module for damage and replace SBC module if necessary.
3. Check 9-pin connector on Star Diagnosis unit and have Star Diagnosis unit repaired if necessary
Symptoms