E 320 4MATIC Sedan (211.082) V6-3.2L (112.954) (2004)
Headlamp Control Module: Service and Repair
AR82.10-P-4632T Remove/Install Xenon Headlamp Control Module
- with CODE (614) Bi-xenon headlamp unit
- with CODE (615) Bi-xenon headlamp unit with integrated curve illumination
Illustrated On Left Lamp Unit
DANGER:
-
Danger from Xenon headlamp high voltage
-
Do not touch parts which conduct high voltages. Persons with active electronic implants (e.g.heart pacemakers) should never work on
xenon headlamps.
1
Disconnect ground cable of battery
2
Remove left front headlamp unit (El)
-
Only when removing the Xenon headlamp supply module (E1n4) of the left front headlamp unit (E1) on vehicles with Code (489a) Airmatic
(semi-active air suspension)
3.1 Remove engine compartment paneling at bottom front
3.2 Remove bottom front part of noise encapsulation.
4
Remove bolts (1)
5
Carefully press off Xenon headlamp supply module (E1n4) from the left front lamp unit (E1) using a longitudinal wedge
See "Special Tools" given below.
NOTE: Installation: Ensure correct seating of gasket (2).
6
Install in the reverse order
Special Tools
Longitudinal Wedge P/N # 115 589 03 59 00