E 320 4MATIC Sedan (211.082) V6-3.2L (112.954) (2004)
1
Remove washer (1) from rubber mount (2).
2
Insert thrust pieces (01a) in the gap between the rubber mount (2) and rear axle carrier (3)
3
Fit bracket (01b) onto rear axle carrier (3).
4
Slide sleeve (01c) over thrust pieces (01a) and insert thrust piece (01d) into the sleeve (01c).
5
Press rubber mount (2) out of rear axle carrier (3) by turning in the spindle (01e).
Install
Component Identification
6
Clean mounting bore in the rear axle carrier (3).
7
Coat a thin layer of rubber assembly fluid on the new rubber mount (2) and in the mounting hole in the rear axle carrier (3).
8
Insert rubber mount (2) in the mounting bore in the rear axle carrier (3).
The cutout (2a) must point towards the vehicle rear.
9
Place thrust piece (01f) on rubber mount (2).
Component Identification
10
Insert thrust piece (01g) in the rear axle carrier (3).
11
Press rubber mount (2) into rear axle carrier (3) by turning in the spindle (01e).