E 320 4MATIC Wagon (210.282) V6-3.2L (112.941) (1998)
3.
The stepped bolt is now visible just below the lower edge of the seat covering or upholstery near the front on both the left and right sides (Figure
2).
4.
Remove original bolt (Figure 3, left bolt) and replace with new bolt with 0-ring (Figure 3, right bolt) on both the door side and tunnel side of the
front seat together with a new crimp nut.
5.
Reinstall affected seat following WIS document AR91.10-P-1000F.
Parts Information
In Case of Warranty, use the table.